Inventor General Discussion

Inventor General Discussion

Reply
*chris
Message 1 of 1 (40 Views)

Assembly of tiny parts on big building !

40 Views, 0 Replies
11-07-2002 05:42 AM
Most of the mechanical parts I'm modeling in IV are tiny, less than 1"
dimension. However, once a while I want to show the customer how the parts
can be installed in a big building, say around 100 m long and 20 m width. If
I am going to create an assembly file for these parts and the building, how
should I set up the environment to make sure the IV wouldn't take too much
time to create 2D dwg from this assembly.
Thank you in advance.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.