Assembly moving parts issue

[Anonymous]

So I have this assembly with all parts constrained properly yet it won't let the parts move the way they should under the constraints applied and it's telling me I have interfering constraints.

I checked the "broken" constraints over but they look fine.

It's a relatively small assembly (10-15 parts), although the parts have been used in a previous assembly. Would this affect their behaviour?

Thanks

[Logos_Atum]

Hello there, you can use the same parts over and over again,

that should not affect the way they are linked in the present

assembly.

It´s hard to tell whether you constrained a single pat wrong or

a greater number of parts. The first part placed in an assembly

is fixed by standard. Did you consider that?

If you don´t mind you can link me to the part and I´ll check

it in the evening (CET).

[JDMather]

---

@Anonymous wrote:

.....all parts constrained properly .....

I checked the "broken" constraints over but they look fine.

It's a relatively small assembly.....

---

Attach the assembly here - I'm betting there is an error in the modeled geometry.
Frequently when someone posts a problem like this one part has a hole pattern with rectangular coordinates and on another layed out on circular pattern.  In any case, it is virtually impossible to say where the error is without seeing the assembly.

[jletcher]

Missing Parts

Axle.ipt

Bolt.ipt

New Spool Wall.ipt

Final Brake Hub.ipt

Poobah of all drive hubs.ipt

Adapter Ring.ipt

30 Sprocket.ipt

Brake 1.ipt

And what I did see you have some learning to do... But you will get there

[JDMather]

All the Spool.iam sub-assembly parts are missing.

Since  this is a sub-assembly you will need to right click on the node in the browser and set to Flexible (not Adaptive) for it to have motion degrees of freedom.

Also I found at least one sick feature/sketch and evidence of too much work (use Tangent and Equal constraints - Inventor should create these for you).