Inventor General Discussion

Reply
Distinguished Contributor
jorgen
Posts: 578
Registered: ‎08-03-2003
Message 1 of 3 (65 Views)

Assembly COG plus for R6 ?

65 Views, 2 Replies
11-28-2002 09:36 PM
I want to have a COG in my drawing for dimensioning.
If I understand correctly, the native COG in R6 cannot do this.

So I downloaded COGplus v1.1 by Niel Munro, and hoped this would work.
But it generated a runtime-error.

Anybody know if there is a version of it that supports R6, or if I did a mistake somewhere??

Jorgen
*Munro, Neil
Message 2 of 3 (65 Views)

Re: Assembly COG plus for R6 ?

11-28-2002 11:54 PM in reply to: jorgen
It will be out shortly (next week). I'll announce it here.

Cheers,
Neil

"jorgen" wrote in message
news:f1283df.-1@WebX.maYIadrTaRb...
I want to have a COG in my drawing for dimensioning.
If I understand correctly, the native COG in R6 cannot do this.
So I downloaded COGplus v1.1 by Niel Munro, and hoped this would work.
But it generated a runtime-error.
Anybody know if there is a version of it that supports R6, or if I did a
mistake somewhere??
Jorgen
Distinguished Contributor
jorgen
Posts: 578
Registered: ‎08-03-2003
Message 3 of 3 (65 Views)

Re:

11-29-2002 03:50 AM in reply to: jorgen
Splendid :smileywink:)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.