Inventor General Discussion

Inventor General Discussion

Reply
Contributor
toddg01
Posts: 20
Registered: ‎08-26-2008
Message 1 of 1 (83 Views)

Assembly and Part file naming after file is generated with excel

83 Views, 0 Replies
07-20-2012 09:38 AM

So with the help of many of you on this forum I have finally managed to get my excel file and inventor working great. I am able to input a few key and generate the Assembly and Part files. Now with this part done what is the proper procedure in saving these files? I was keeping the Excel file exported if possible but not 100% needed. The paramaters are shared between the assembly and parts now.

 

Thanks,

 

Todd

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.