Inventor General Discussion

Inventor General Discussion

New Member
Posts: 2
Registered: ‎11-11-2002
Message 1 of 1 (46 Views)

Assemblies controlled with excel sheets

46 Views, 0 Replies
11-07-2002 08:53 PM
I am working in a smal manufacturing company which makes flow measurement equipment. The products are based on a standard but they are also made according to the customers wishes. The assemblies are built with a flow measuring device made according to the flow. On this part minimum two pressure tappings are mounted.
These pressure tappings vary in sizes, they also different thread size and even some have butt weld and socket weld ends. In some cases valves are mounted on as well.

I can do all the above mentioned things with MDT with a single excel sheet.

Are there any way to do similar things in Inventor?

Best regards

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.