Inventor General Discussion

Inventor General Discussion

Reply
*Miller, Steve
Message 1 of 3 (28 Views)

Any possibility of a Mold Design pachage in IV?

28 Views, 2 Replies
12-16-2002 11:51 PM
That is the question of the day around here. Unless there is one on the
horizon we will drop our subscription to Inventor Series and stick with
MDT 6 or switch to Pro/E and use their mold design option.

Steve Miller
Pre Plastics
Distinguished Contributor
rllthomas
Posts: 2,068
Registered: ‎12-10-2003
Message 2 of 3 (28 Views)

Re: Any possibility of a Mold Design pachage in IV?

12-17-2002 01:58 AM in reply to: *Miller, Steve
How about Mold Factory?
*Jeffrey, Dennis
Message 3 of 3 (28 Views)

Re: Any possibility of a Mold Design pachage in IV?

12-17-2002 05:57 AM in reply to: *Miller, Steve
These features will come.... what specifically are you looking for in a
package? Have you investigated Derived parts and 3D paths for parting
lines?

Dennis

Steve Miller wrote:

> That is the question of the day around here. Unless there is one on the
> horizon we will drop our subscription to Inventor Series and stick with
> MDT 6 or switch to Pro/E and use their mold design option.
>
> Steve Miller
> Pre Plastics

--
Dennis Jeffrey
CAD Associates - Fort Wayne
Autodesk University Instructor
Autodesk ASC
(260-432-9695 x 221
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.