Inventor General Discussion

Inventor General Discussion

Reply
*mpower
Message 1 of 2 (42 Views)

Angle dimension won't stay

42 Views, 1 Replies
12-05-2002 01:03 AM
On this drawing, I can place this angle dimension, save the drawing, close
the drawing, open it, and the dimension has an error every time! What's up?

It also says when I open the .idw that the .iam is not resolved. That's not
true because I saved the .iam when I save the .idw.

-Mike
*Singlehurst, Rob
Message 2 of 2 (42 Views)

Re: Angle dimension won't stay

12-05-2002 01:32 AM in reply to: *mpower
I had exactly the same error. I worked out that it was because one of the
ends of each line weren't coincident. I created a sketch on the view and
projected the lines I needed. Trimmed them so that the endpoints were
coincident - returned from the sketch and created the dimension and now it's
OK. I am sure this would have worked fine in 5.3 though.

--
Cheers,

--Rob Singlehurst
"mpower" wrote in message
news:E5D340778D23127B07461E2CA405740B@in.WebX.maYIadrTaRb...
> On this drawing, I can place this angle dimension, save the drawing, close
> the drawing, open it, and the dimension has an error every time! What's
up?
>
> It also says when I open the .idw that the .iam is not resolved. That's
not
> true because I saved the .iam when I save the .idw.
>
> -Mike
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.