Inventor General Discussion

Inventor General Discussion

Reply
*mpower
Message 1 of 2 (43 Views)

Angle dimension won't stay

43 Views, 1 Replies
12-05-2002 01:03 AM
On this drawing, I can place this angle dimension, save the drawing, close
the drawing, open it, and the dimension has an error every time! What's up?

It also says when I open the .idw that the .iam is not resolved. That's not
true because I saved the .iam when I save the .idw.

-Mike
*Singlehurst, Rob
Message 2 of 2 (43 Views)

Re: Angle dimension won't stay

12-05-2002 01:32 AM in reply to: *mpower
I had exactly the same error. I worked out that it was because one of the
ends of each line weren't coincident. I created a sketch on the view and
projected the lines I needed. Trimmed them so that the endpoints were
coincident - returned from the sketch and created the dimension and now it's
OK. I am sure this would have worked fine in 5.3 though.

--
Cheers,

--Rob Singlehurst
"mpower" wrote in message
news:E5D340778D23127B07461E2CA405740B@in.WebX.maYIadrTaRb...
> On this drawing, I can place this angle dimension, save the drawing, close
> the drawing, open it, and the dimension has an error every time! What's
up?
>
> It also says when I open the .idw that the .iam is not resolved. That's
not
> true because I saved the .iam when I save the .idw.
>
> -Mike
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!