I had exactly the same error. I worked out that it was because one of the
ends of each line weren't coincident. I created a sketch on the view and
projected the lines I needed. Trimmed them so that the endpoints were
coincident - returned from the sketch and created the dimension and now it's
OK. I am sure this would have worked fine in 5.3 though.
--
Cheers,
--Rob Singlehurst
"mpower" wrote in message
news:E5D340778D23127B07461E2CA405740B@in.WebX.maYIadrTaRb...
> On this drawing, I can place this angle dimension, save the drawing, close
> the drawing, open it, and the dimension has an error every time! What's
up?
>
> It also says when I open the .idw that the .iam is not resolved. That's
not
> true because I saved the .iam when I save the .idw.
>
> -Mike
>
>