Inventor General Discussion

Reply
Active Contributor
lemaycj
Posts: 45
Registered: ‎09-07-2011
Message 1 of 5 (261 Views)
Accepted Solution

Aligning parts

261 Views, 4 Replies
04-19-2012 04:01 PM

Here's another one which I am sure is an easy task for most but has me frustrated....

 

I have added 4 gussets to my assembly of two parts.  All I am trying to do is to align the gussets 90 degrees apart from each other and starting at 45 degrees on each side of the tapped hole.  I have one almost positioned except it can still move along the surface.  How should I tackle this?

Mate the workplane to the central axis.

Valued Contributor
cean_au
Posts: 100
Registered: ‎07-11-2011
Message 2 of 5 (256 Views)

Re: Aligning parts

04-19-2012 04:56 PM in reply to: lemaycj

when u finish the first, array out the rest.

 

and if you creat one part insetad of an assembly, the gusset can be rib feature, much eash to creat.

Active Contributor
lemaycj
Posts: 45
Registered: ‎09-07-2011
Message 3 of 5 (219 Views)

Re: Aligning parts

04-24-2012 08:41 AM in reply to: cean_au

The problem with this issue is not how to do the next 3 but how to secure the one where it needs to go and/or is there a better way than the way I was placing that gusset to be more efficient at it.

Active Contributor
Jonka45
Posts: 29
Registered: ‎03-30-2011
Message 4 of 5 (212 Views)

Re: Aligning parts

04-24-2012 09:05 AM in reply to: lemaycj

You are virtually there, Use a mate constraint from the plane you created to the plane through the center of the gusset then pattern the gusset to get 4 instances at 90 degrees.

Inventor 2015 Proffesional
Dell Precision T3500 Intel Xeon
Windows 7
Quadro 4000
Inside Leg 35 inch
*Expert Elite*
JDMather
Posts: 27,474
Registered: ‎04-20-2006
Message 5 of 5 (210 Views)

Re: Aligning parts

04-24-2012 09:10 AM in reply to: lemaycj

Mate the workplane to the central axis.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.