Inventor General Discussion

Reply
Valued Contributor DMF
Valued Contributor
DMF
Posts: 58
Registered: ‎06-29-2003
Message 1 of 3 (39 Views)

Adding this dimension

39 Views, 2 Replies
11-07-2002 11:20 PM
When I draw a scetch, on a scetch plane or scetch surface, and want to place dimensions on that scetch. It sometimes says, adding this dimesion will over contrain the scetch. I usually redraw the scetch and then I can place a dimension. why does this happen?
*Maas, Karl
Message 2 of 3 (39 Views)

Re: Adding this dimension

11-07-2002 11:27 PM in reply to: DMF
Many times while you're drawing lines in a sketch,
IV is adding constraint automatically. You're probably trying to dimension
something unnecessarily. IV tries to keep you from adding unneeded dimensions
and constraints. If you're puzzled as to what constraints are holding you back,
you can use the "Show Constraints" tool.


--
K

 

 


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
When
I draw a scetch, on a scetch plane or scetch surface, and want to place
dimensions on that scetch. It sometimes says, adding this dimesion will over
contrain the scetch. I usually redraw the scetch and then I can place a
dimension. why does this happen?
*Yeandle, Laurence
Message 3 of 3 (39 Views)

Re: Adding this dimension

11-09-2002 03:41 AM in reply to: DMF
Also accept driven dimension when prompted (you
might have to adjust application options/sketch tab ) the driven dimension will
serve its purpose for reference the value and will simply change with the
already constrained geometry.


--
Laurence,
--


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
When
I draw a scetch, on a scetch plane or scetch surface, and want to place
dimensions on that scetch. It sometimes says, adding this dimesion will over
contrain the scetch. I usually redraw the scetch and then I can place a
dimension. why does this happen?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.