Inventor General Discussion

Inventor General Discussion

Reply
New Member
vasily_gorbounov
Posts: 1
Registered: ‎04-27-2012
Message 1 of 2 (148 Views)
Accepted Solution

adding physical boundaries in assemblies

148 Views, 1 Replies
04-27-2012 10:00 AM

How do I set a constraint where 2 parts are attached to each other but do not phase through. For example if I have a door in a door frame, how do I add a constraint where the door can swing on it's hinges but get stopped by the door frame.

Either by using constraint limits or via contact solver... I'd use constraint limits..

*Expert Elite*
mcgyvr
Posts: 7,248
Registered: ‎12-01-2004
Message 2 of 2 (141 Views)

Re: adding physical boundaries in assemblies

04-27-2012 10:35 AM in reply to: vasily_gorbounov

Either by using constraint limits or via contact solver... I'd use constraint limits..

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2015 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.