Inventor General Discussion

Inventor General Discussion

Reply
New Member
vasily_gorbounov
Posts: 1
Registered: ‎04-27-2012
Message 1 of 2 (139 Views)
Accepted Solution

adding physical boundaries in assemblies

139 Views, 1 Replies
04-27-2012 10:00 AM

How do I set a constraint where 2 parts are attached to each other but do not phase through. For example if I have a door in a door frame, how do I add a constraint where the door can swing on it's hinges but get stopped by the door frame.

Either by using constraint limits or via contact solver... I'd use constraint limits..

*Expert Elite*
mcgyvr
Posts: 6,985
Registered: ‎12-01-2004
Message 2 of 2 (132 Views)

Re: adding physical boundaries in assemblies

04-27-2012 10:35 AM in reply to: vasily_gorbounov

Either by using constraint limits or via contact solver... I'd use constraint limits..

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

-------------------------------------------------------------------------------------
2015 Product Design Suite Ultimate
Windows 7 64 bit
Core i7 4820k processor (OC'd to 4.4Ghz), Nvidia GTX 770, 16G RAM


Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.