Thanks a lot it was really an informative article, however, I wend through SDK folder and when I install Derive Scale Positon Addin, nothing will add on my IV, even in Addins list nothing shows up , I had it before I upgrade to IV2013 and it was easy and powerful, but I cannot get it to install anymore and I'm wondering why.
Thanks anyways for all the support
I forgot to mention that the reason that article doesnt work for me at the moment is, I'm dealing with Derived Sketch reorientation/positioning/scale , not a solid body and thats exactly what derived part scale/position was capable of.
Please see if this discussion thread has anything useful:
I believe that you need to have at least the.NET platform 2.0 installed.
I assume that you know about SDK which needs to be installed using UserTools.msi typically found under C:\Users\Public\Documents\Autodesk\Inventor 2012\SDK\.
Make sure that the old addin is uninstalled first. I am not sure if cleaning the registry (for entries referring to derivedpart_sp) is necessary.
Sorry, I cannot be of much help here. Good luck!
Perhaps this post is quite relevant -- apparently there is a GUID collision with another addin in Inventor 2013. Try to install the addin which Rocky Zhang has posted there. Thanks.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!