Inventor General Discussion

Reply
Contributor
marconiman
Posts: 15
Registered: ‎07-30-2003
Message 1 of 2 (44 Views)

Adaptive

44 Views, 1 Replies
11-26-2002 03:03 AM
hi,

I created a adaptive part and saved it. but unfortunately it was the wrong location. now i moved it to the right location. then i replaced the part in my assembly. but then.. the part is no longer adaptive. even the option adaptive is grayed. what can i do to make it adaptive again?

thx
*Caldwell, Larry
Message 2 of 2 (44 Views)

Re: Adaptive

11-26-2002 03:16 AM in reply to: marconiman
That's because IV thinks it's already adaptive
and it can only be adaptive once. You can go to Tools/Document Settings/Model
and uncheck adaptive; then it should work.

~Larry

 


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
hi,

I created a adaptive part and saved it. but unfortunately it was the wrong
location. now i moved it to the right location. then i replaced the part in my
assembly. but then.. the part is no longer adaptive. even the option adaptive
is grayed. what can i do to make it adaptive again?

thx

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.