Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Has anyone had problems with the adaptive design in relation to sheet metal products? It seems that if I have more than 2 flanges, the part will not adapt to the mating part. I would chalk it up to operator error had I not taken several different approaches but I am not going to rule that out.
I love the adaptive design in sheet metal I have
not experienced your issue I have not had a problem. I would make sure your sub
features are set to adaptive in the part your trying to make grow
Has
anyone had problems with the adaptive design in relation to sheet metal
products? It seems that if I have more than 2 flanges, the part will not adapt
to the mating part. I would chalk it up to operator error had I not taken
several different approaches but I am not going to rule that
out.
Has
anyone had problems with the adaptive design in relation to sheet metal
products? It seems that if I have more than 2 flanges, the part will not adapt
to the mating part. I would chalk it up to operator error had I not taken
several different approaches but I am not going to rule that
out.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")