Inventor General Discussion

Inventor General Discussion

Reply
Contributor
ericjed13
Posts: 20
Registered: ‎10-09-2012
Message 1 of 1 (118 Views)

Acceptable Quality on Part Fill Analysis?

118 Views, 0 Replies
10-09-2012 11:05 PM

Okay, so i'm running a simulation on my plastic part and I got myself a result of 67.8% High, 32.2% Medium, and 0% Low on its Quality Prediction graph.

 

My questions now are these:

 

is this result acceptable?

is there a rule of thumb or a formula on which i could make an assessment of whether the quality plot of a part is acceptable or not?

 

Hope you could respons ASAP.

 

Thank you!

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.