Inventor General Discussion

Inventor General Discussion

Reply
Contributor
ericjed13
Posts: 20
Registered: ‎10-09-2012
Message 1 of 1 (119 Views)

Acceptable Quality on Part Fill Analysis?

119 Views, 0 Replies
10-09-2012 11:05 PM

Okay, so i'm running a simulation on my plastic part and I got myself a result of 67.8% High, 32.2% Medium, and 0% Low on its Quality Prediction graph.

 

My questions now are these:

 

is this result acceptable?

is there a rule of thumb or a formula on which i could make an assessment of whether the quality plot of a part is acceptable or not?

 

Hope you could respons ASAP.

 

Thank you!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.