Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
eman6398
Posts: 79
Registered: ‎05-23-2007
Message 1 of 2 (153 Views)

2013 BOUNDARY PATCH SELECTION NOT VISIBLE

153 Views, 1 Replies
05-01-2012 01:32 PM

when using the boundary patch command, placing your mouse over a sketch profile highlights the area, after it has been selected and clicked on the highlighted selection turn clear, so I cant tell if it has been selected or not. the command still works, but knowing what you have selected is difficult. once the command is finished, then you can see the surface which is transparent.

Dell t1500 i7 8 gb ram
Windows 7 64 bit
ati firepro v4800

Employee
johnsonshiue
Posts: 2,092
Registered: ‎04-30-2008
Message 2 of 2 (151 Views)

Re: 2013 BOUNDARY PATCH SELECTION NOT VISIBLE

05-01-2012 01:40 PM in reply to: eman6398

Hi! This is a great catch! It seems to happen on sketch loop selection. The preview of the patch surface is not shown, which is wrong. I am sending it to development for further review.

Many thanks!

 



Johnson Shiue (johnson.shiue@autodesk.com)
Principal SQA Engineer, Inventor
Mechanical Design
Autodesk, Inc.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.