Inventor Fusion

Inventor Fusion

Reply
Distinguished Contributor
FProcp
Posts: 170
Registered: ‎10-21-2009
Message 1 of 2 (270 Views)
Accepted Solution

Want to draw a line using Δx and Δy not angle, dist?

270 Views, 1 Replies
10-18-2012 07:24 AM

I want to draw a line using Δx and Δy not angle and distance?

 

By default you can enter a distance and an angle when you draw your next line in a sketch.

Is there any way to define the next line using difference in x and difference in y ?

 

I would of thought you should be able to right click and switch to Δx,Δy

 

Surely there's a way ??:smileyfrustrated:

Franc
inventor :-)

Hi Franc,

 

Thanks for using our product. We are sorry to tell you that Fusion cannot support this behavior currently, and we will consider it as an improvement in future releases.

 

Employee
SallyYang
Posts: 107
Registered: ‎07-31-2012
Message 2 of 2 (259 Views)

Re: Want to draw a line using Δx and Δy not angle, dist?

10-18-2012 07:07 PM in reply to: FProcp

Hi Franc,

 

Thanks for using our product. We are sorry to tell you that Fusion cannot support this behavior currently, and we will consider it as an improvement in future releases.

 

Regards,
Sally



Sally Yang
Software QA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.