Inventor Fusion

Inventor Fusion

Reply
Distinguished Contributor
FProcp
Posts: 172
Registered: ‎10-21-2009
Message 1 of 2 (273 Views)
Accepted Solution

Want to draw a line using Δx and Δy not angle, dist?

273 Views, 1 Replies
10-18-2012 07:24 AM

I want to draw a line using Δx and Δy not angle and distance?

 

By default you can enter a distance and an angle when you draw your next line in a sketch.

Is there any way to define the next line using difference in x and difference in y ?

 

I would of thought you should be able to right click and switch to Δx,Δy

 

Surely there's a way ??:smileyfrustrated:

Franc
inventor :-)

Hi Franc,

 

Thanks for using our product. We are sorry to tell you that Fusion cannot support this behavior currently, and we will consider it as an improvement in future releases.

 

Employee
SallyYang
Posts: 115
Registered: ‎07-31-2012
Message 2 of 2 (262 Views)

Re: Want to draw a line using Δx and Δy not angle, dist?

10-18-2012 07:07 PM in reply to: FProcp

Hi Franc,

 

Thanks for using our product. We are sorry to tell you that Fusion cannot support this behavior currently, and we will consider it as an improvement in future releases.

 

Regards,
Sally



Sally Yang
Software QA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.