Inventor Fusion

Reply
Contributor
Mattaxe
Posts: 22
Registered: ‎07-22-2009
Message 1 of 3 (184 Views)

Sweep?

184 Views, 2 Replies
07-24-2009 06:53 PM
I cant seem to sweep a sketched line (x,y) along a curved path (x,z) to create a concave/convex work plane/surface as in previous versions. Which I might then project geometry onto. Edited by: Mattaxe on Jul 25, 2009 2:13 AM
Employee
jeff.strater
Posts: 173
Registered: ‎08-28-2006
Message 2 of 3 (184 Views)

Re: Sweep?

07-25-2009 11:18 AM in reply to: Mattaxe
Currently, Fusion does not support surface modeling at all. Only solids are supported.

Thanks for the feedback

Jeff Strater (Fusion development team)
Contributor
Mattaxe
Posts: 22
Registered: ‎07-22-2009
Message 3 of 3 (184 Views)

Re: Sweep?

07-25-2009 08:11 PM in reply to: Mattaxe
OK...... except I was trying to create a customized work plane of the "Translucent type". (but yes I think its called a surface in Inventor 2008).

Looking forward to full functionality.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.