Inventor Fusion

Inventor Fusion

Reply
Distinguished Contributor
richardporqueddu6731
Posts: 249
Registered: ‎10-24-2005
Message 1 of 2 (165 Views)

Reccomend a workflow please / small example

165 Views, 1 Replies
06-30-2009 10:35 AM
Hello Kevin,
I see you seem to be moderating this board, so I'll direct this to you. I saw the example of the cube and hole you did elesware on here, and for the life of me I would have never had figured it out.
So here is a real world project I would like to try with Fusion. I have the attached frame and I need to add "pads" to the I-beams as per attached photo (I did in 2010) and change the through holes in each end into extruded pins which face in. I've fooled around all morning with no significant progress. Can you give me an idea of the workflow I might want to try?
Regards,
Rick
Distinguished Contributor
richardporqueddu6731
Posts: 249
Registered: ‎10-24-2005
Message 2 of 2 (165 Views)

Re: Reccomend a workflow please / small example

06-30-2009 10:35 AM in reply to: richardporqueddu6731
Here is the photo of what I would like it to look like.
Rick
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.