Inventor Fusion

Reply
Valued Contributor
azmand01
Posts: 69
Registered: ‎01-05-2012
Message 1 of 4 (307 Views)

Printing / Hiding Red Origin Dots

307 Views, 3 Replies
08-14-2012 05:45 AM

I have a bunch of solids imported (copy pasted as new component) in a maind model that shows their creation Red Dot point.

 

When printing they still show. Is there anyway to hide them?

 

Thanks

 

Employee
Macro.Liu_Autodesk
Posts: 98
Registered: ‎05-26-2008
Message 2 of 4 (291 Views)

Re: Printing / Hiding Red Origin Dots

08-14-2012 07:50 PM in reply to: azmand01

I assume these are original points in Sketch. When Sketches are invisible, those points should be invisible.

 

So please find the component that one red point belongs to, expand the browser node and then expand 'Sketches', click the Bulb to set the sketches invisible.

 

Hope this helps. If it's not working, please share one of your files with me and I'll take a further look.

 

Thanks,

Macro Liu

Autodesk Inventor Fusion QA

Valued Contributor
azmand01
Posts: 69
Registered: ‎01-05-2012
Message 3 of 4 (285 Views)

Re: Printing / Hiding Red Origin Dots

08-15-2012 04:17 AM in reply to: Macro.Liu_Autodesk

Thanks.

 

Sketches were buried deep down the three.

Employee
Macro.Liu_Autodesk
Posts: 98
Registered: ‎05-26-2008
Message 4 of 4 (273 Views)

Re: Printing / Hiding Red Origin Dots

08-15-2012 06:47 PM in reply to: azmand01

So it may be easier to set the sketches to invisible after you copying one component that has this Red Dot.

 

Thanks,

Macro Liu

Inventor Fusion QA Team

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.