Inventor Fusion

Active Member
Posts: 6
Registered: ‎03-30-2013
Message 1 of 4 (974 Views)
Accepted Solution

Oval offset not working?

974 Views, 3 Replies
03-30-2013 10:31 PM

I'm fairly new to Inventor Fusion, so maybe I'm just not doing this correctly, but sketch oval offsets don't seem to be working in build 576.1.0 of Inventor Fusion Technology for Mac. I can get ellipse offsets to work (with the nearest axis highlighting), but curve-equidistant offsets (i.e. 'oval offsets' as per the manual) don't seem available- with the 'offset' command active, I'm not able to click on any point of the elliptical curve that is not near an axis. Both the Wiki and manual indicate this should be possible.



*Expert Elite*
Posts: 27,501
Registered: ‎04-20-2006
Message 2 of 4 (958 Views)

Re: Oval offset not working?

04-01-2013 06:27 AM in reply to: mixnmatch

Does it work in Fusion 360?

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
Active Member
Posts: 6
Registered: ‎03-30-2013
Message 3 of 4 (941 Views)

Re: Oval offset not working?

04-02-2013 06:33 AM in reply to: JDMather

Yes, it does work in Fusion 360! Though I've noticed Fusion 360 does this odd 'pinching' of an inset oval (just on one side of the major axis), once you approach the inset limit.

Posts: 761
Registered: ‎10-26-2008
Message 4 of 4 (615 Views)

Re: Oval offset not working?

05-06-2014 07:43 AM in reply to: mixnmatch

rmb enable loop select & then try offset. it should work.

Inventor Professional 2015
Vault Professional 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.