Inventor Fusion

Active Member
Posts: 6
Registered: ‎03-30-2013
Message 1 of 4 (1,000 Views)
Accepted Solution

Oval offset not working?

1000 Views, 3 Replies
03-30-2013 10:31 PM

I'm fairly new to Inventor Fusion, so maybe I'm just not doing this correctly, but sketch oval offsets don't seem to be working in build 576.1.0 of Inventor Fusion Technology for Mac. I can get ellipse offsets to work (with the nearest axis highlighting), but curve-equidistant offsets (i.e. 'oval offsets' as per the manual) don't seem available- with the 'offset' command active, I'm not able to click on any point of the elliptical curve that is not near an axis. Both the Wiki and manual indicate this should be possible.



*Expert Elite*
Posts: 28,228
Registered: ‎04-20-2006
Message 2 of 4 (984 Views)

Re: Oval offset not working?

04-01-2013 06:27 AM in reply to: mixnmatch

Does it work in Fusion 360?

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
Active Member
Posts: 6
Registered: ‎03-30-2013
Message 3 of 4 (967 Views)

Re: Oval offset not working?

04-02-2013 06:33 AM in reply to: JDMather

Yes, it does work in Fusion 360! Though I've noticed Fusion 360 does this odd 'pinching' of an inset oval (just on one side of the major axis), once you approach the inset limit.

Posts: 765
Registered: ‎10-26-2008
Message 4 of 4 (641 Views)

Re: Oval offset not working?

05-06-2014 07:43 AM in reply to: mixnmatch

rmb enable loop select & then try offset. it should work.

Inventor Professional 2015
Vault Professional 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.