Inventor Fusion

Reply
Distinguished Contributor
andrew.nao
Posts: 207
Registered: ‎09-25-2008
Message 1 of 2 (107 Views)

need some refresher instructions on sweeping

107 Views, 1 Replies
03-21-2012 08:10 AM
its been a few years since i used inventor, so im messing with fusion right now till i get back in the groove before i buy inventor when sweeping, i made a circle sketch on top plane. then i made a spline on the front plane starting from the center of the circle on the top plane two different sketches, two different planes. but it wont let me sweep, i need to peirce the plane... how do i make the spline peirce the plane?
*Expert Elite*
JDMather
Posts: 27,575
Registered: ‎04-20-2006
Message 2 of 2 (106 Views)

Re: need some refresher instructions on sweeping

03-21-2012 08:19 AM in reply to: andrew.nao

andrew.nao wrote:
.... but it wont let me sweep, i

Attach the file here.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.