Inventor Fusion

Reply
New Member
alex.becker
Posts: 2
Registered: ‎02-17-2014
Message 1 of 2 (254 Views)

Multiple Part Files in Inventor Fusion Mac

254 Views, 1 Replies
02-20-2014 05:50 PM

So I use Inventor at school; of course they use windows based products, but I have a MacBook. I downloaded Inventor off the Mac App Store. I noticed it's lacking in many ways eg. cannot create polygon, cannot loft, etc. Anyways, I was wondering if there was a way that I could have multiple part files open at the same time, like you can on PC. Because whenever I create a new part file it closes the one I was working on, regardless if I saved it or not. It is VERY annoying. So, is there a way that I can have multiple projects open at the same time, and be able to just click and work between my two projects? Any help would be greatly appreciated, thanks. 

Board Manager
Phil.E
Posts: 339
Registered: ‎06-29-2012
Message 2 of 2 (223 Views)

Re: Multiple Part Files in Inventor Fusion Mac

02-25-2014 08:03 AM in reply to: alex.becker

Have you considered using Autodesk Fusion 360? It has polygon and loft and multi-document ability. It also runs on Mac.

 

Check it out! Fusion 360.



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.