Inventor Fusion

Reply
Distinguished Contributor
gcross
Posts: 193
Registered: ‎01-11-2001
Message 1 of 2 (303 Views)

Moving features in IV Fusion 2012

303 Views, 1 Replies
11-22-2011 11:45 AM

I need help on how to move a feature in Fusion. So far I haven't found a tutorial that shows this.

 

I have a couple cylinders on a part representing wires that I need to move a bit & I can't seem to get that to happen nor have I been able to find anything in Wikihelp or the discussion group.

 

Should be pretty simple I would think. I tried selecting the feature first but Move cmd asks for entities & my highlighted selection goes away.

 

If I move entities (I can only select the end circles not the cylinder)  the shape warps.

 

Gary

Product Design Suite Ultimate 2014
Employee
udayag
Posts: 90
Registered: ‎06-07-2010
Message 2 of 2 (296 Views)

Re: Moving features in IV Fusion 2012

11-22-2011 04:07 PM in reply to: gcross

Did you check out this Wiki article?

 

http://wikihelp.autodesk.com/Inventor_Fusion/enu/2012/Help/0056-Modeling56/0133-Direct_M133/0135-Mov...

 

It has a video under "show me how to move geometry" that shows how to move a cylindrical hole which is quite similar to what you are trying to do.

Udaya Gunasena
Fusion Development
Autodesk
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.