Inventor Fusion

Reply
Active Member
digital_dreamer
Posts: 7
Registered: ‎12-09-2012
Message 1 of 4 (597 Views)

Making assembled pieces move together

597 Views, 3 Replies
12-11-2012 10:32 PM

Would someone be able to summarize briefly how bodies/components are ordered in Fusion so that they move/animate as expected?

 

I've put together a two-solenoid motor that animates as expected with one solenoid. However when assembling the opposing solenoid, I've not been successful. As soon as I get the connecting rod attached to the crank, it breaks with "Selected joint type will result in conflict", "Angle conflict due to joint type", and "Distance conflict due to joint type", although it's basically the same as the other side.

 

Now, I just decided to see if the opposing solenoid can function on its own, with the other solenoid disconnected and it fails. Both plunger and hub/crank can move independently, but, when connected, fails. I'd like to understand what's going on.

 

The opposing solenoid is made up of mirrored non-moving parts and copied/pasted moving parts (plunger, connecting rods and linkage). Something is wrong with my understanding of body/component placement in the browser and the way I've set it up. Or, perhaps, Fusion, at this stage, just can't comprehend movement of opposing/mirrored parts.

 

Any ideas?

 

Solenoid motor file

 


Active Member
digital_dreamer
Posts: 7
Registered: ‎12-09-2012
Message 2 of 4 (573 Views)

Re: Making assembled pieces move together

12-22-2012 05:33 PM in reply to: digital_dreamer

Success!

I've finally completed this little project.

 

The secret to getting interdependent moving parts working is to ensure all parts are properly aligned prior to assembly. You can't expect Fusion to resolve all joint issues at once. This can be rather tricky and may take a number of different paths. I had to slide the solenoid cylinder out away from the plunger first, so Fusion could resolve those joint conflicts first. Let Fusion align the parts, then move cylinder back into position.

I think having more than one part out of alignment at once can throw Fusion into conFusion. :smileywink:

 

MAJ

 

New Member
xtofury
Posts: 2
Registered: ‎01-04-2013
Message 3 of 4 (526 Views)

Re: Making assembled pieces move together

01-04-2013 09:56 AM in reply to: digital_dreamer

Which t-slot system is that you are using?   (the aluminum bars with the slots in them).... that one looks different than the ones I have been looking at.

Active Member
digital_dreamer
Posts: 7
Registered: ‎12-09-2012
Message 4 of 4 (523 Views)

Re: Making assembled pieces move together

01-04-2013 10:41 AM in reply to: xtofury

They are just the 25 series (Metric) of the 80/20 t-slots.

 

CAD models are available, too.

 

best of wishes,

MAJ

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.