I imported a part via step and arrayed it with 6 parts. Fusion now is very slow. I have saved and reloaded the part but even just moving the mouse over the menus gives me the color wheel. Activity monitor shows CPU usage at 100%
Is there some sort of setting to optimize here? Its not a particularly complex model. Maybe the system doesn't like imported data perhaps? The step file was 3.7Mb and I'm running on a 2.3 GHz i7 macbook pro with 8Gb ram.
Thanks for raising up this performance issue! I am very appriciate if you can share the file to us, as it will help us to address the issue quickly.
Thanks for your quickly response, and I think I can catch the problem finally. I have added it to our defect list and hope it could be resolved in our later version.
Thanks again for your feedback, it's really helpful to us. Hoping to get more valuable feedback from you again!
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!