Inventor Fusion

Reply
New Member
kyliecummings14
Posts: 1
Registered: ‎12-16-2012
Message 1 of 2 (251 Views)

Inventor fusion installation failure

251 Views, 1 Replies
12-16-2012 01:38 PM

I am having trouble installing inventor fusion. I have installed and autocad will open but when I try to open fusion splash screen opens, then i get a notification that there was an error while initializing the graphics subsystem. it says that it could be from the graphics driver not being configured to true color. As far as I can tell it is, but I am not sure. any help I can get would be greatly appreciated!!! Thanks

Employee
Macro.Liu_Autodesk
Posts: 98
Registered: ‎05-26-2008
Message 2 of 2 (245 Views)

Re: Inventor fusion installation failure

12-16-2012 06:11 PM in reply to: kyliecummings14

Would you please check if  the version of your graphic driver is the latest. If not, please upgrade to the latest version and then launch again.

 

Thanks,

Macro Liu

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.