Inventor Fusion

Reply
New Member
Moanli.Thete
Posts: 1
Registered: ‎06-05-2014
Message 1 of 1 (127 Views)

Inventor Fusion and Inventor LT API Programming

127 Views, 0 Replies
06-05-2014 02:22 AM

Hi,

I have downloaded Inventor Fusion 2013 R1.
I have few queries:
1. I want to write a ipt file from a input sat file using it. Is it possible?

2. I was thingking for a Translator Addin to do this task but I am unable to find the SDk or API programming help for the same. I am not sure, if Inventor Fusion provides these type of enhancements.

3. Just as Inventor has a "Inventor.Application" ProgID from which CLSID can be hooked up, Is there a similar way for Inventor Fusion to run it in Silent mode.

Same steps I am trying with Inventor LT 2014. This does support "FileSaveAs" for ipt format but I want to hook this up programatically from my application (if Inventor LT is installed on a machine).

Kindly guide me for the same. In-case of any further ideas to hook this up, I would be glad to have them from you.

 

Regards,
Monali

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.