Inventor Fusion

New Member
Posts: 1
Registered: ‎09-07-2012
Message 1 of 2 (279 Views)

Inventor fusion 2013

279 Views, 1 Replies
09-07-2012 02:04 PM

Hi, somebody help please. I used some older versions of Inventor. In this new program when I start sketching I don't get the display part where you put the dimension, there is a white prompt indicating "enter the dimension" but you don't have where to put it, so you don't have a chanse to draw a circle of the dimention you need.


Posts: 90
Registered: ‎08-07-2011
Message 2 of 2 (259 Views)

Re: Inventor fusion 2013

09-10-2012 04:23 AM in reply to: qbpmgm

For your problem. If you want just create a circle with your dimension, you can try below workflows:


1.Invoke Circle command;

2.Click any point of the sketch area;

3.Move the mouse somewhere;

4.Input value you want;

5.Click again;

6.Double click the circle you created, now you can edit the value of it.


You also can refer to Fusion help here:


Hope this solve your problem.


SQA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.