Inventor Fusion

Reply
New Member
qbpmgm
Posts: 1
Registered: ‎09-07-2012
Message 1 of 2 (282 Views)

Inventor fusion 2013

282 Views, 1 Replies
09-07-2012 02:04 PM

Hi, somebody help please. I used some older versions of Inventor. In this new program when I start sketching I don't get the display part where you put the dimension, there is a white prompt indicating "enter the dimension" but you don't have where to put it, so you don't have a chanse to draw a circle of the dimention you need.

Thanks.

Employee
Mike.Zhang
Posts: 123
Registered: ‎08-07-2011
Message 2 of 2 (262 Views)

Re: Inventor fusion 2013

09-10-2012 04:23 AM in reply to: qbpmgm

For your problem. If you want just create a circle with your dimension, you can try below workflows:

 

1.Invoke Circle command;

2.Click any point of the sketch area;

3.Move the mouse somewhere;

4.Input value you want;

5.Click again;

6.Double click the circle you created, now you can edit the value of it.

 

You also can refer to Fusion help here:

http://wikihelp.autodesk.com/Inventor_Fusion/enu/2013

 

Hope this solve your problem.

Regards,



Mike.Zhang
SQA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.