Inventor Fusion

*Expert Elite*
Posts: 4,312
Registered: ‎04-27-2005
Message 1 of 2 (152 Views)

Intersecting Surface - Best Practice

152 Views, 1 Replies
08-23-2013 11:16 AM

I brought a part in fom Inventor.  When I do a Validate, I have an intersecting surface. Normally I would just delete the intersecting surface and then patch it back in.  Here, if I just delete the intersecting surface, I will loose part of the profile of the part becaused it is on an edge.


 What is the best/easiest way to take care of this in Fusion? 



Board Manager
Posts: 362
Registered: ‎06-29-2012
Message 2 of 2 (142 Views)

Re: Intersecting Surface - Best Practice

08-26-2013 12:30 PM in reply to: karthur1

Have you tried to trim the intersecting surfaces?

Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!