Inventor Fusion

Reply
*Expert Elite*
karthur1
Posts: 4,204
Registered: ‎04-27-2005
Message 1 of 2 (141 Views)

Intersecting Surface - Best Practice

141 Views, 1 Replies
08-23-2013 11:16 AM

I brought a part in fom Inventor.  When I do a Validate, I have an intersecting surface. Normally I would just delete the intersecting surface and then patch it back in.  Here, if I just delete the intersecting surface, I will loose part of the profile of the part becaused it is on an edge.

 

 What is the best/easiest way to take care of this in Fusion? 

 

Thanks

Board Manager
Phil.E
Posts: 285
Registered: ‎06-29-2012
Message 2 of 2 (131 Views)

Re: Intersecting Surface - Best Practice

08-26-2013 12:30 PM in reply to: karthur1

Have you tried to trim the intersecting surfaces?



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.