Inventor Fusion

Reply
Member
zjerla
Posts: 3
Registered: ‎06-17-2013
Message 1 of 5 (1,764 Views)
Accepted Solution

Importing STP files into Inventor Fusion

1764 Views, 4 Replies
06-17-2013 05:59 PM

I am trying to import a 46MB STP file into Inventor Fusion and the file is not opening correctly. When Inventor Fusion opens the STP file I see only one part of the assembly. Inventor Fusion immediately creates an Error Log file that is 583KB. The goal is to open the STP File convert it to a DWG and create section views. I can open smaller 1079KB STP files abd can convert them to DWG's. Any thoughts?

Fusion 360 solved the problem. Thus far I am able to open all the .STP files. Fusion 360 is a great program and is doing the job.

 

Thanks for all your help.

 

 

Board Manager
Phil.E
Posts: 340
Registered: ‎06-29-2012
Message 2 of 5 (1,694 Views)

Re: Importing STP files into Inventor Fusion

07-16-2013 08:54 AM in reply to: zjerla

Hi,

 

Thanks for posting! Can you post the STP file and/or the error log so our development team can have a look?

 

Thanks!

 

 



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Member
zjerla
Posts: 3
Registered: ‎06-17-2013
Message 3 of 5 (1,690 Views)

Re: Importing STP files into Inventor Fusion

07-16-2013 07:07 PM in reply to: Phil.E

Phil,

 

I have attached the  error log. Let me know if you settle on any conclusions. Cheers,

Board Manager
Phil.E
Posts: 340
Registered: ‎06-29-2012
Message 4 of 5 (1,678 Views)

Re: Importing STP files into Inventor Fusion

07-17-2013 10:44 AM in reply to: zjerla

Thanks for posting the log.

 

It's hard to tell from the log what's going on. If you can post the original file here or email to me at phil dot eichmiller at autodesk dot com, that would help.

 

Thanks,

 



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Member
zjerla
Posts: 3
Registered: ‎06-17-2013
Message 5 of 5 (1,670 Views)

Re: Importing STP files into Inventor Fusion

07-17-2013 11:35 PM in reply to: Phil.E

Fusion 360 solved the problem. Thus far I am able to open all the .STP files. Fusion 360 is a great program and is doing the job.

 

Thanks for all your help.

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.