Inventor Fusion

Reply
Active Member
sean.s.rafferty
Posts: 6
Registered: ‎05-01-2012
Message 1 of 4 (284 Views)

Fusion For Mac- Lofting Help Needed!!

284 Views, 3 Replies
01-10-2013 01:30 AM

I am using Fusion for Mac and need to create the shape shown below (created using Sketchup):

 

Solid Example

 

How can I create this in Fusion for Mac? I see no loft tools, and do not have the ability to freeform distort a cylinder to shape one either. 

 

Please help!!!

Employee
SallyYang
Posts: 107
Registered: ‎07-31-2012
Message 2 of 4 (246 Views)

Re: Fusion For Mac- Lofting Help Needed!!

01-20-2013 07:54 PM in reply to: sean.s.rafferty

Thank you for using Fusion, this function will be supported in our future releases.

And hoping to get your feedback again for this new function.

Regards,
Sally



Sally Yang
Software QA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Active Member
sean.s.rafferty
Posts: 6
Registered: ‎05-01-2012
Message 3 of 4 (244 Views)

Re: Fusion For Mac- Lofting Help Needed!!

01-20-2013 08:39 PM in reply to: SallyYang
Is there an estimated date when this update will take place and this functionality will be enabled?
Employee
SallyYang
Posts: 107
Registered: ‎07-31-2012
Message 4 of 4 (237 Views)

Re: Fusion For Mac- Lofting Help Needed!!

01-20-2013 10:52 PM in reply to: sean.s.rafferty

I think it will be supported in the nearly future and please pay attention to the message from our company.   Thank you for understanding.

Regards,
Sally



Sally Yang
Software QA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.