Inventor Fusion

Reply
New Member
Keiji2
Posts: 1
Registered: ‎06-27-2013
Message 1 of 2 (386 Views)

Fusion 2013R1

386 Views, 1 Replies
07-23-2013 09:02 AM

Hi, I use Inventor 2014, Simulation Mech2014 and Fusion 2013 R1.

I want to read Inventor 2014 data by Fusion 2013 R1.

But cannot open Inventor 2014 Data. Is this not possible?

 

Thank you.

K2

Board Manager
AndrewSears
Posts: 324
Registered: ‎08-21-2010
Message 2 of 2 (369 Views)

Re: Fusion 2013R1

07-24-2013 06:17 PM in reply to: Keiji2

Hi K2,

 

This is not possible.  You should have seen an error in the bottom of Fusion telling you the reason.

 

Andy

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.