Inventor Fusion

Reply
New Member
v.orlando
Posts: 2
Registered: ‎11-26-2012
Message 1 of 3 (626 Views)
Accepted Solution

Fusion 2013 error

626 Views, 2 Replies
02-19-2013 06:08 AM

Hi.

 

I've been working and got the following error trying to save: "Object reference not set to an instance of an object"

 

I've pinpointed the cause of the error. I can save until a fillet 2 lines. 

 

error1_1.jpg

 

error1_2.jpg

 

error1_4.jpg

 

This is Inventor Fusion 2013 on Windows 7 x64 Pro.

 

Any clues?

Board Manager
Phil.E
Posts: 281
Registered: ‎06-29-2012
Message 2 of 3 (581 Views)

Re: Fusion 2013 error

02-25-2013 11:29 AM in reply to: v.orlando

Does this happen with any fillet between two sketch lines?



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

New Member
v.orlando
Posts: 2
Registered: ‎11-26-2012
Message 3 of 3 (576 Views)

Re: Fusion 2013 error

02-25-2013 11:44 AM in reply to: Phil.E

In the end I found out that it was that the radius was to large, once I learned how to use the tool, everything went A-OK

 

 

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.