Inventor Fusion

Inventor Fusion

Reply
Active Member
kurt_steinke
Posts: 9
Registered: ‎02-19-2013
Message 1 of 4 (334 Views)

File "in use or read only" error

334 Views, 3 Replies
02-19-2013 10:11 AM

Inventor Fusion 2013 locked up and I had to shut my computer down without closing the file I was working on. Now both the file I was working on and its .bak (when renamed) give me a "file is currently in use or is read-only" error. Neither is the case. Renaming the file or copying it does not fix the problem. What's the fix?

Board Manager
Phil.E
Posts: 376
Registered: ‎06-29-2012
Message 2 of 4 (307 Views)

Re: File "in use or read only" error

02-25-2013 08:41 AM in reply to: kurt_steinke

The file was recovered, but is missing some information. Please find it attached.

Regards,

 



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Board Manager
Phil.E
Posts: 376
Registered: ‎06-29-2012
Message 3 of 4 (302 Views)

Re: File "in use or read only" error

02-25-2013 11:23 AM in reply to: kurt_steinke

Can you describe what you were doing when Fusion locked up? If you can provide steps to reproduce it that would be very helpful!

Thanks,

 



Phil Eichmiller
Software QA Engineer
Fusion Quality Assurance Team
Autodesk, Inc.

Active Member
kurt_steinke
Posts: 9
Registered: ‎02-19-2013
Message 4 of 4 (266 Views)

Re: File "in use or read only" error

03-08-2013 12:02 PM in reply to: Phil.E

Suppress "Component3:2" and you can see screw heads that interfere. I was trying various means (unsuccessfully) to try to move them so they would not interfere. Other than cursing Inventor Fusion and its programers vehemently, don't recall the specific unsuccessful means of moving a screw I was trying when it crashed.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.