Inventor Fusion

Inventor Fusion

New Member
1 Posts
0 Kudos
Registered: ‎01-29-2013
Post 1 of 2

Duplicating 3D script in Inventor Fusion

290 Views, 1 Replies
01-29-2013 02:58 PM

Hello.  As a project for my new 3d printer I thought that I would scan the emblem on the back of my car, switch a few of the letters around and reprint the emblem to spell something new.  I Live Traced the image in Illustrator CS6, exported it as a DWG and brought it into Autocad 2013.  Contrary to the article here I haven't been able to copy and paste the shape from Autocad into Inverntory Fusion UNLESS I extrude the shape.  Not a tragedy but now I'm attempting to fillet the edges like the original emblem and Fusion says that the entire outline is too complicated to filet.  Is there another way to achieve nice uniformly rounded edges?  The Autocad DWG (which can be opened in Inventor Fusion) and a picture of the original emblem (so you can see the original filleting) are attached below  TIA for any advice you can give.

119 Posts
7 Kudos
Registered: ‎07-31-2012
Post 2 of 2

Re: Duplicating 3D script in Inventor Fusion

02-06-2013 11:52 PM in reply to: pricebill

The DWG file you attached couldn' t be opened by Inventor Fusion and AutoCAD, please double check it and upload again.

Thank you!


Sally Yang
Software QA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post