Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am using Inventor 2010, While solid modeling a in ANSI scale i have been attempting to thread an 8 inch diameter hub and the largest nominal diamiter in the library is 4. Also while producing a drawing i have multiple surface marks and was curious if there is a possibility to scale the size of the marks down to fit them into tight spaces. Feedback is apprecaited
