Geometry processing failed solid body could be mapped back to inventor entity

[ashish.patilSP94R]

I am trying to run a stress simulation on a rolling device I created with Inventor. However I keep getting this error preventing me from moving forward. I have been searching for a solution to this error but did not have any luck finding a relevant article. I will be happy to post my model should anyone request it. I get this error when I click on mesh and run stress analysis

[johnsonshiue]

Hi! I have not seen this error before. Nor was it reported by other users. Try this and see if there is any bad body reported.

Go to the Modeling environment -> press Ctrl+F7. Check the dialog to see if there is a bad body.

If yes, please run Repair Bodies workflow to fix up the badness.

Many thanks!