Inventor Engineer-to-Order

Inventor Engineer-to-Order

Reply
Active Contributor
bigvik
Posts: 46
Registered: ‎01-03-2011
Message 1 of 2 (113 Views)

Invalid pointer while creating center line

113 Views, 1 Replies
10-04-2011 06:05 AM

Hello,

 

In past project I generated a drawing, then projected some points and used those points to create a circular center line. Everything worked fine that time but I am trying to replicate that part of the code for a new project but for some reason I haven't been able to figure out I get an "Invalid Pointer" error while evaluating %%updateself. By trial and error, I discovered I that I was able to either project the points or generate the circular center line, but not both at the same time (I need to do both at the same time so the points show up with and angle).

 

I cannot recreate the error because, as I said, it used to work fine on past projects.

 

Is there a know issue that shows up seemingly at random while creating circular centerlines?

Active Contributor
bigvik
Posts: 46
Registered: ‎01-03-2011
Message 2 of 2 (104 Views)

Re: Invalid pointer while creating center line

10-05-2011 03:20 PM in reply to: bigvik

I forgot to specify, I am using Intent 2011Version 4.0 Build: 129 with Inventor 2011

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.