Community
Inventor Engineer-To-Order (Read-Only)
Welcome to Autodesk’s Inventor ETO Forums. Share your knowledge, ask questions, and explore popular Inventor ETO topics.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Hatch on Inventor Drawing view

1 REPLY 1
Back to Inventor Engineer-to-Order (Read-Only) Category
Back to Topic Listing
Reply
Message 1 of 2
gadurai
Contributor
1172 Views, 1 Reply
‎08-04-2013 10:53 PM
‎08-04-2013 10:53 PM

Hatch on Inventor Drawing view

Hi,

 

Is it possible to create Hatch on the selected part on the Inventor drawing view through ETO rule?.

 

Regards,

Appadurai.G

 

 

Report
0 Likes
Reply
1 REPLY 1
Message 2 of 2
yuri.kozak
Contributor
in reply to: gadurai
‎08-23-2013 08:44 AM
‎08-23-2013 08:44 AM

Hello.

 

In Inventor the hatch should appeared automaticly after a cross section has been created.

If not, try to set up material and/or properties of "IvSectionView" design.

 

Yuri

Report
0 Likes
Reply
Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

Report a website issue