Inventor Engineer-to-Order

Reply
Contributor
CalvinDay
Posts: 22
Registered: ‎11-18-2011
Message 1 of 3 (263 Views)

Books

263 Views, 2 Replies
11-18-2011 11:57 AM

Are there any good guides or books so I can learn ETO?

Active Contributor
tmckeand
Posts: 37
Registered: ‎11-23-2011
Message 2 of 3 (241 Views)

Re: Books

11-23-2011 06:55 AM in reply to: CalvinDay

The best help I found is the wiki http://wikihelp.autodesk.com/Inventor_ETO/enu/2012/Help/0000-Inventor0

 

and working through the Conveyor tutorial

Distinguished Mentor
pcrawley
Posts: 693
Registered: ‎05-23-2002
Message 3 of 3 (231 Views)

Re: Books

11-23-2011 11:55 PM in reply to: tmckeand
I just sat through 4 days of ETO training using the Autodesk Official Training Courseware (AOTC) material. The course was fantastic and the material eases you into ETO whilst remaining a good reference guide. (Wish the course had been much longer as it was so good!) Not sure if you can buy the book on its own (you'll need the support files, otherwise it's pointless) - try your local reseller? Peter
Peter
Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.