Inventor Customization

Posts: 22
Registered: ‎12-31-2008
Message 1 of 1 (104 Views)

using ilogic and substitutes

104 Views, 0 Replies
04-18-2011 01:04 PM

I am having some issues with ilogic and the use of substitues. Here is my structure:


Main Level Assembly

-Sub Assembly

  -Base Component


I have an ilogic rule that pushes parameters from the main level to the base component. It works well but now the assemblies are getting very large and RAM is an issue. Is there any way to still push the paramters from the main to the base component if the sub assembly is a substitute level of detail? Or is there a better way to fix this problem?



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.