Inventor Customization

Reply
*Stubbington, Scott
Message 1 of 2 (44 Views)

Profiles

44 Views, 1 Replies
11-15-2003 09:27 PM
Hello,
I've just created a pipe programmatically, extruded it to a non adaptive
workplane.
What's scary is the fact that Inventor has selected the right region. I'm
also a little concerned by this, how do I specify the correct region? In
the
pipe profile I obviously have 2 circles, one for the Outside diameter and
one for the inside diameter. How did the region between the two circles get
picked and not the region that is the the inside of the inside diameter
circle?

Thanks

Scott
*Ham, Teun
Message 2 of 2 (44 Views)

Re: Profiles

11-16-2003 08:39 PM in reply to: *Stubbington, Scott
I assume you have created the outer circle first, than the inner circle?
What if you switch those two? Is the region still correct?

You should be able to define which region you want for you profile...

"Scott Stubbington" wrote in message
news:B4907FD5F36F4F3E3376DEE54D649D94@in.WebX.maYIadrTaRb...
> Hello,
> I've just created a pipe programmatically, extruded it to a non adaptive
> workplane.
> What's scary is the fact that Inventor has selected the right region. I'm
> also a little concerned by this, how do I specify the correct region? In
> the
> pipe profile I obviously have 2 circles, one for the Outside diameter and
> one for the inside diameter. How did the region between the two circles
get
> picked and not the region that is the the inside of the inside diameter
> circle?
>
> Thanks
>
> Scott
>
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.